This article mainly introduces:

Turkmenistan hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Turkmenistan shearing machine cylinder,produced by Hengyu Group）

shearing machine cylinder are widely used in Turkmenistan，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed shearing machine cylinder for customers from Turkmenistan.

Introduction to shearing machine cylinder:

After chrome plating of the piston rod of the shearing machine cylinder, the surface flatness is not fully treated: After chrome plating of the piston rod surface, the method of post-plating polishing should be changed to post-plating polishing. Although it is necessary to increase the thickness of the coating before grinding (generally increased by about 0.02 in the diameter direction), it can remove chrome plating defects well, and test the binding force of the coating. In addition, due to the micro-roughness of the grinding surface, the trough can store lubricating oil, which can improve the wear resistance and extend the service life.

The commonly used buffer structure of the shearing machine cylinder is composed of a piston boss and a shearing machine cylinder head groove. When the piston moves close to the shearing machine cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The main role of the shearing machine cylinder: the shearing machine cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the shearing machine cylinder realizes reciprocating motion. The structure of the shearing machine cylinder has three categories: piston shearing machine cylinder, plunger shearing machine cylinder, swing shearing machine cylinder, piston shearing machine cylinder and plunger shearing machine cylinder to achieve reciprocating linear motion, output speed and thrust, swing shearing machine cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the shearing machine cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The shearing machine cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

Causes and countermeasures of oil shearing machine cylinder leakage: Cast iron ring seal allows a certain degree of internal leakage. The impurities in the shearing machine cylinder will lead to premature wear of the piston seal, replace the piston seal; If the shearing machine cylinder is visibly scarred, the shearing machine cylinder must be replaced. It can be pressurized at one end of the shearing machine cylinder and opened at the other end of the oil port to observe whether there is obvious internal leakage at the end of the oil port. Most shearing machine cylinder piston drift may not come from the shearing machine cylinder, the above method to determine the shearing machine cylinder without internal leakage is helpful to determine the problem of the hydraulic system related components.

Answers to some questions about shearing machine cylinder:

What is the bearing capacity of the HOB cylinder?
The normal specification of HOB is 140 kg pressure, which is more commonly used in the market, and there are clear marks on the cylinder, 210 kg is a strengthened version of HOB, generally customized cylinders are also clearly marked on the above, when the specific use of the cylinder, the maximum use pressure is marked on the cylinder.

How does the hydraulic solenoid valve realize that the cylinder stops at any position?
Use an O-type medium function solenoid directional valve, or use a Y-type solenoid directional valve and a hydraulically controlled check valve.