This article mainly introduces:

Norway hydraulic cylinder,hydraulic gate cylinder manufacturer,hydraulic gate cylinder

(Norway hydraulic gate cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic gate cylinder are widely used in Norway，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed hydraulic gate cylinder for customers from Norway.

Introduction to hydraulic gate cylinder:

When the hydraulic gate cylinder is in use, ensure that the hydraulic gate cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

How to determine the working pressure of the hydraulic gate cylinder: The pressure depends on the load size (i.e., F) and the type of equipment. The limitations of assembly space, economic conditions and component availability of the actuator should also be considered. In the case of a certain load, it is necessary to increase the structural size of the actuator if the working pressure is low, for some equipment, the size may be limited, and it is not economical from the point of view of material consumption; On the contrary, if the pressure selection is too high, the material, sealing and manufacturing accuracy of the pump, hydraulic gate cylinder, valve and other components are also required to be high, which will inevitably increase the cost of equipment. In general, for equipment with a fixed size that is not too limited, the pressure can be selected lower, and the walking machinery should be selected higher.

Do not regularly check the damage of the chrome layer of the hydraulic gate cylinder: completely extend the hydraulic gate cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the hydraulic gate cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the hydraulic gate cylinder seal. Welding slag is strictly prohibited on the surface of the hydraulic gate cylinder.

The repair method of hydraulic gate cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.

Answers to some questions about hydraulic gate cylinder:

A hydraulic system functions three cylinders to maintain pressure, what components need to be used?
Two way cartridge valve can be selected for control. Two way cartridge valve advantages: 1) flow capacity is large, especially suitable for large flow occasions. 2) The spool has sensitive action and strong anti-clogging ability. 3) Good sealing, small leakage, oil flow through the valve pressure loss is small. 4) Simple structure, easy to standardize.

What is the difference between hydraulic piston cylinder and plunger cylinder?
The force surface of the piston cylinder is a rod cavity and a rodless cavity, and the force surface of the plunger cylinder is the plunger, the spring return single-acting piston cylinder can also rely on the external force of the spring to achieve return, the double-acting piston cylinder can produce tension, and the plunger cylinder only produces thrust without tension.