This article mainly introduces:

Algeria hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Algeria stroke adjustable cylinder,produced by Hengyu Hydraulic Co., Ltd）

stroke adjustable cylinder are widely used in Algeria，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed stroke adjustable cylinder for customers from Algeria.

Introduction to stroke adjustable cylinder:

Do not regularly check the damage of the chrome layer of the stroke adjustable cylinder: completely extend the stroke adjustable cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the stroke adjustable cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the stroke adjustable cylinder seal. Welding slag is strictly prohibited on the surface of the stroke adjustable cylinder.

stroke adjustable cylinder hydraulic oil selection: The recommended working oil viscosity of the stroke adjustable cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

In recent years, the processing process of the stroke adjustable cylinder generally adopts the rolling method, which is a pressure finishing processing, which uses the cold plastic characteristics of the metal at room temperature, and uses the rolling tool to exert a certain pressure on the surface of the workpiece, so that the surface metal of the workpiece produces plastic flow, and fills in the low concave trough of the original residue, and the roughness value of the workpiece surface is reduced. Due to the plastic deformation of the rolled surface metal, the surface tissue is cold hardened and the grain is fine, forming a dense fiber, and forming a residual stress layer, and the hardness and strength are increased, thus improving the wear resistance, corrosion resistance and compatibility of the workpiece surface. Rolling is a plastic machining method without cutting.

When the stroke adjustable cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the stroke adjustable cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

Answers to some questions about stroke adjustable cylinder:

How to distinguish loader boom and forearm hydraulic cylinder? Is it the upper arm or the lower arm?
The one in the middle that can flip the bucket is the small arm cylinder you say, and the one that lifts the brackets (big arms) on both sides is the big arm cylinder.

What is the rated pressure of the general cylinder?
This depends on the model of the cylinder, 1. The rated pressure of the light tie rod cylinder is 7 series 7MPa and 14 series 14MPa. 2. Rated pressure of engineering cylinder 16MPa. 3. Rexroth type metallurgical cylinder rated pressure 250MPa.