This article mainly introduces:

Australia hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Australia steering power cylinder,produced by Hebei Hengyu company）

steering power cylinder are widely used in Australia，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed steering power cylinder for customers from Australia.

Introduction to steering power cylinder:

When the steering power cylinder needs to be stored for a period of time, please follow the recommended methods: The steering power cylinder should be stored in a dry, clean, non-corrosive gas indoor environment, pay attention to protect the steering power cylinder from internal corrosion and external damage. If the indoor requirements cannot be met, the hardened and well-drained ground should be cushioned at least 30cm, and the upper part should be covered with waterproof storage. The oil steering power cylinder should not be in direct contact with water vapor for a long time. The steering power cylinder should be placed as vertically as possible with the piston rod facing up, which minimizes corrosion due to possible condensation in the steering power cylinder and permanent deformation of the seal due to the piston and rod weight. (When the shield is stored in the shield machine, the support shoe is placed upward). Keep the oil port protective cover until the pipe is connected. For long-term storage, the protection should be added on both sides of the piston of the steering power cylinder Before working, the steering power cylinder must be run repeatedly with low pressure (greater than the starting pressure) to discharge the air in the steering power cylinder before normal work. The oil inlet and outlet and the joint must be tightly fastened with a combination pad to prevent oil leakage.

steering power cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards steering power cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the steering power cylinder guide is determined by the length of the stroke. Check the strength of steering power cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

When the steering power cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the steering power cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The steering power cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the steering power cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the steering power cylinder wall due to the stiffness and the weight of the parts, causing scars.

Answers to some questions about steering power cylinder:

By what means can the hydraulic system control the arbitrary stroke position of the rotary cylinder piston rod?
The following ways can be considered: 1, through the limit device, such as limit switch, position sensor, etc. 2, by feedback the pressure of the hydraulic oil in the cylinder. The load determines the pressure, the pressure in the cylinder is determined by the load, and the pressure is very small when the cylinder is unloaded. 2.1 When clamping the workpiece, the pressure of the cylinder increases, by calculating the relationship between the clamping force and the pressure of the cylinder, take a pressure value of the cylinder, set the pressure switch, and drive the valve to work when the pressure reaches the preset value, so that the oil circuit stops supplying oil. 2.2 or set the pressure value of the relief valve to overflow after a certain set pressure.

Is there a way to make the cylinder stop pushing when it hits something hard during the process of pushing?
The simplest solution is to press the stop switch, this switch has a mechanical type, touch the object on the action or send a stop signal, through the operation of the motor control cylinder; There is also an induction switch, that is, when the hydraulic cylinder expands to the range of the induction switch can sense the signal, it sends a signal to let the motor act, resulting in the corresponding action of the cylinder.