This article mainly introduces:

Indonesia hydraulic cylinder,pressure plate hydraulic cylinder manufacturer,pressure plate hydraulic cylinder

(Indonesia pressure plate hydraulic cylinder,produced by Hebei Hengyu company）

pressure plate hydraulic cylinder are widely used in Indonesia，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed pressure plate hydraulic cylinder for customers from Indonesia.

Introduction to pressure plate hydraulic cylinder:

pressure plate hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. pressure plate hydraulic cylinder selection specifications are too small. Leakage in pressure plate hydraulic cylinder or associated hydraulic system element.

After the pressure plate hydraulic cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

When the pressure plate hydraulic cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the pressure plate hydraulic cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

pressure plate hydraulic cylinder buffer valve inspection and maintenance: For the valve buffer pressure plate hydraulic cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

Answers to some questions about pressure plate hydraulic cylinder:

How does the clamping cylinder work?
Hydraulic transmission principle: oil as the working medium, through the change of the sealing volume to transfer movement, through the internal pressure of the oil to transfer power. 1. The power part - converts the mechanical energy of the prime mover into the pressure energy of the oil (hydraulic energy). For example: hydraulic pump. 2, The executive part - the hydraulic pump input oil pressure energy into the mechanical energy to drive the working mechanism. For example: hydraulic cylinder, hydraulic motor. 3, The control part - used to control and adjust the oil pressure, flow and flow direction. For example: pressure control valve, flow control valve and direction control valve. 4, The auxiliary part - the first three parts are connected together to form a system, which plays the role of oil storage, filtration, measurement and sealing.

To achieve the same stroke, which is better, hydraulic cylinder or lead screw?
If there is batch action, then the hydraulic pressure is better. Hydraulic: smooth operation, no lubrication, easy control, high control accuracy (can use proportional or servo system), the key is to manually control, but certainly to support the hydraulic system, for a single action must cost. Maintenance costs are also high. Lead screw: simple structure, easy to achieve, convenient maintenance, but must be lubricated, can not be manual, or manual control is inconvenient. See where it is used, if it is used in high-precision occasions, it must only be hydraulic, because the lead screw has a gap. There are many hydraulic actions, the hydraulic system itself must be prepared, then the use of hydraulic pressure is also very economical.