This article mainly introduces:

Mexico hydraulic cylinder,rolling mill cylinder manufacturer,rolling mill cylinder

(Mexico rolling mill cylinder,produced by Hengyu Hydraulic Cylinder Factory）

rolling mill cylinder are widely used in Mexico，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed rolling mill cylinder for customers from Mexico.

Introduction to rolling mill cylinder:

The commonly used buffer structure of the rolling mill cylinder is composed of a piston boss and a rolling mill cylinder head groove. When the piston moves close to the rolling mill cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The body of the rolling mill cylinder on the processing process requirements: the body of the rolling mill cylinder is an important and essential part of the rolling mill cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the rolling mill cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

The oil rolling mill cylinder is a part of the hydraulic system, in the hydraulic system, to reasonably design the heat dissipation system, to prevent the oil temperature is too high is the key to keep the hydraulic oil temperature normal. The temperature of the system should be kept in a suitable range to reduce the energy released when the bubble bursts. While not affecting the normal circulation of the coolant, a certain amount of anti-corrosion additives can be appropriately added to inhibit rust. When operating the hydraulic system, we should strive to be stable, not too fast, too strong, and try to reduce the impact of hydraulic oil on hydraulic components.

The definition of the minimum starting pressure of the rolling mill cylinder refers to the minimum working pressure of the rolling mill cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the rolling mill cylinder parts and the size of the sealing friction.

Answers to some questions about rolling mill cylinder:

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.

What size of hydraulic cylinder is needed for 200 tons pressure? The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate by the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the pressure level P (unit MPa) when working, then the thrust of the cylinder F push =3.14*R*R*P (unit N) the pull of the cylinder F pull =3.14* (R* R-R *R) *P (unit N) 100 tons of the cylinder, System pressure 16Mpa.