This article mainly introduces:

UAE hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(UAE track steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

track steering cylinder are widely used in UAE，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed track steering cylinder for customers from UAE.

Introduction to track steering cylinder:

track steering cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

If the seal of the track steering cylinder is abnormal wear, you can check whether the speed control valve is improperly adjusted, resulting in too high back pressure and improper installation of the seal or hydraulic oil contamination. The second is whether there is a foreign body entering the assembly and the quality of the sealing material is not good. The result is that the action is slow and weak, and in serious cases, it will cause damage to the piston and track steering cylinder, and the phenomenon of "pulling the track steering cylinder" appears. The treatment method is to adjust the speed control valve, and the necessary operation and improvement should be done according to the installation instructions.

When the piston speed of the track steering cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the track steering cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

When the track steering cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the track steering cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

Answers to some questions about track steering cylinder:

How to limit cylinder push rod rotation?
In general, the push-rod rotation can be limited after the push-rod is connected to the pushed mechanism. For example, the push rod is hinged with the push mechanism, or the push mechanism itself is guided, which can limit the rotation of the push rod.

How is the hydraulic cylinder tempered?
The purpose of the tempering treatment is to make the piston rod have comprehensive mechanical properties of strength, hardness, plasticity and toughness, and the internal structure is uniform and fine tempered sorbite, so as to prepare the organization for subsequent surface quenching. The length of the long cylinder piston rod is 3800-4200, and the diameter is Φ90-Φ110mm, so its heating equipment uses a 150KW well resistance furnace or 600KW suspension continuous resistance heating furnace, and the temperature is controlled by two areas. Heat treatment process parameters: in the shaft furnace, a furnace is suspended with 4 pieces, the quenching heating temperature is 830±10℃, and after holding heat for 160min, it is divided into two times for quenching, and two pieces are quenched each time, and the circulating cooling water is used for cooling.