This article mainly introduces:

Jordan hydraulic cylinder,supporting cylinder manufacturer,supporting cylinder

(Jordan supporting cylinder,produced by Hengyu Group）

supporting cylinder are widely used in Jordan，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed supporting cylinder for customers from Jordan.

Introduction to supporting cylinder:

The wear of the hard chromium plating layer of the supporting cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

The main role of the supporting cylinder: the supporting cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the supporting cylinder realizes reciprocating motion. The structure of the supporting cylinder has three categories: piston supporting cylinder, plunger supporting cylinder, swing supporting cylinder, piston supporting cylinder and plunger supporting cylinder to achieve reciprocating linear motion, output speed and thrust, swing supporting cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the supporting cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The supporting cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

supporting cylinder use should try to avoid sealing belt into the supporting cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the supporting cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the supporting cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

When the supporting cylinder is disassembled due to oil leakage and other faults, the position of the piston should be moved to any end position of the supporting cylinder by applying liquid pressure. Improper tapping and sudden drop should be avoided during disassembly.

Answers to some questions about supporting cylinder:

Why can't the hydraulic cylinder be replaced with water?
Hydraulic oil for hydraulic transmission has a variety of requirements for viscosity, density, flow rate, and temperature, which are not available for water.

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.