This article mainly introduces:

Cameroon hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(Cameroon track steering cylinder,produced by Hengyu Hydraulic Cylinder Factory）

track steering cylinder are widely used in Cameroon，because of no need for deceleration device，long service life，smooth movement.So our company has designed track steering cylinder for customers from Cameroon.

Introduction to track steering cylinder:

The track steering cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

The track steering cylinder is not the same as the track steering cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the track steering cylinder can not be used as a high-power power component, but the track steering cylinder can be used as a relatively large power component, or the track steering cylinder system can be used.

track steering cylinder installation precautions: Before installing the track steering cylinder into the system, the parameters on the track steering cylinder label should be compared with the parameters when ordering. The base of the track steering cylinder must have sufficient stiffness, otherwise the track steering cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.

The track steering cylinder should be vented: when the track steering cylinder is installed or parked for a long time to work again, the air will penetrate into the track steering cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the track steering cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the track steering cylinder, the oil is best entered and discharged from the highest point of the track steering cylinder. track steering cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

Answers to some questions about track steering cylinder:

Can one hydraulic pump with two cylinders work?
A hydraulic pump with two cylinders will work. Commonly used hydraulic pump types: 1, according to whether the flow can be adjusted can be divided into: variable pump and quantitative pump. The output flow can be adjusted according to the needs of the variable pump, the flow can not be adjusted called quantitative pump. 2, according to the pump structure commonly used in the hydraulic system is divided into: gear pump, vane pump and plunger pump 3 kinds. Gear pump: small volume, simple structure, the cleanliness of the oil requirements are not strict, the price is cheaper; However, the pump shaft is subjected to unbalanced force, serious wear and leakage. Vane pump: divided into double acting vane pump and single acting vane pump. The pump has uniform flow, smooth operation, low noise, higher pressure and volumetric efficiency than gear pump, and more complex structure than gear pump.

How long can a hydraulic cylinder work continuously?
If the maintenance is good, the service life can be extended a lot. The life of the cylinder is related to the structure of the cylinder, working pressure, stress state, hydraulic oil cleanliness, oil temperature control, maintenance and preventive measures. For example, the cylinder structure, the inner wall of the cylinder has quilting, rolling, chrome plating and other methods, the sealing parts have polyurethane rings, glay rings, metal sealing rings, etc., different combinations, the life difference is dozens of times. Metallurgical system is a typical cylinder application, in 24 hours of work, a year or more can not be shut down, in the middle of continuous work.