This article mainly introduces:

Canada hydraulic cylinder,track steering cylinder manufacturer,track steering cylinder

(Canada track steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

track steering cylinder are widely used in Canada，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed track steering cylinder for customers from Canada.

Introduction to track steering cylinder:

track steering cylinder diameter, rod diameter, stroke determination: Choose national standards or other standards track steering cylinder, avoid the selection of non-standard size, otherwise the difficulty of processing and manufacturing costs will be increased. The length of the track steering cylinder guide is determined by the length of the stroke. Check the strength of track steering cylinder, piston rod, screw, etc. according to the working pressure or load. At the same time, working pressure, ambient temperature, working medium and running speed are also the key to selecting seals.

When using the track steering cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the track steering cylinder block. If the track steering cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the track steering cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the track steering cylinder, so that the working efficiency of the track steering cylinder is reduced.

track steering cylinder spool stuck or valve hole blocked How to solve: When the flow valve or direction valve spool stuck or valve hole blocked, the track steering cylinder prone to misoperation or action failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check the wear of the valve body, clean and replace the system filter, clean the fuel tank, and replace the hydraulic medium.

Protection of the track steering cylinder surface: During the dismantling process, safety protection should be carried out on the track steering cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the track steering cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the track steering cylinder should be cleaned up in time.

Answers to some questions about track steering cylinder:

Why does the cylinder pop out of itself when it stops?
This situation has two possibilities, 1. There is more air in the system, so exhaust the gas. 2. The back pressure of the oil return is relatively large, check the oil return filter, check whether the cylinder has a rod cavity buffer is too tight, and choose a 3-position 4-way M-type valve for the reversing valve. In addition, after the shutdown, manually change the reversing valve back and forth several times, it should not rise out.

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.