This article mainly introduces:

Guatemala hydraulic cylinder,stainless steel cylinder manufacturer,stainless steel cylinder

(Guatemala stainless steel cylinder,produced by Hengyu Hydraulic Cylinder Factory）

stainless steel cylinder are widely used in Guatemala，because of no need for deceleration device，long service life，smooth movement.So our company has designed stainless steel cylinder for customers from Guatemala.

Introduction to stainless steel cylinder:

The pressure of the sliding surface of the stainless steel cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the stainless steel cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

The wear of the hard chromium plating layer of the stainless steel cylinder is mostly caused by the grinding of the friction iron powder of the piston, and the wear is faster when there is water in the middle. Corrosion caused by the contact potential difference of the metal only occurs in the part of the piston contact, and the corrosion occurs in a point pattern. As mentioned above, when there is moisture in the middle, it will promote the development of corrosion. Compared with castings, the contact potential difference of copper alloy is higher, so the corrosion degree of copper alloy is more serious.

If it is found that the stainless steel cylinder lubrication is poor or the stainless steel cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the stainless steel cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the stainless steel cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the stainless steel cylinder center line. In this way, when the piston works in the stainless steel cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the stainless steel cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

Most of the failure of the stainless steel cylinder is because there is a foreign body in the stainless steel cylinder into the failure of the stainless steel cylinder, the most problematic is that it is difficult to determine when the foreign body is into the stainless steel cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about stainless steel cylinder:

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.