This article mainly introduces:

Denmark hydraulic cylinder,pressure plate hydraulic cylinder manufacturer,pressure plate hydraulic cylinder

(Denmark pressure plate hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

pressure plate hydraulic cylinder are widely used in Denmark，because of powerful torque，excellent temperature resistance，no transmission clearance.So our company has designed pressure plate hydraulic cylinder for customers from Denmark.

Introduction to pressure plate hydraulic cylinder:

If the seal of the pressure plate hydraulic cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

pressure plate hydraulic cylinder buffer valve inspection and maintenance: For the valve buffer pressure plate hydraulic cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

The difference between the integral pressure plate hydraulic cylinder and the split pressure plate hydraulic cylinder: The integral pressure plate hydraulic cylinder and the split pressure plate hydraulic cylinder in the pressure plate hydraulic cylinder are two different pressure plate hydraulic cylinders, and they are very different. The whole pressure plate hydraulic cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split pressure plate hydraulic cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and pressure plate hydraulic cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

When installing the pressure plate hydraulic cylinder, the axial ends of the pressure plate hydraulic cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the pressure plate hydraulic cylinder, there is axial expansion. If the two ends of the pressure plate hydraulic cylinder are fixed, all parts of the pressure plate hydraulic cylinder will be deformed. When disassembling the pressure plate hydraulic cylinder, it is strictly forbidden to hammer the pressure plate hydraulic cylinder and the piston surface, such as the pressure plate hydraulic cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

Answers to some questions about pressure plate hydraulic cylinder:

How does the cylinder of the shearing machine work?
Plate shear is a machine that cuts a sheet with a reciprocating straight motion from one blade to another. Through the moving upper blade and the fixed lower blade, the shear force is applied to the metal sheet of various thicknesses with a reasonable blade gap, so that the sheet is broken and separated according to the required size. Shearing machine belongs to one of the forging machinery, the main role is the metal processing industry. Products are widely used in aviation, light industry, metallurgy, chemical industry, construction, shipbuilding, automobile, electric power, electrical appliances, decoration and other industries to provide the required special machinery and complete sets of equipment. Working principle: The hydraulic system is used to drive the hydraulic cylinder to output a strong shear force to complete the shearing work.

Why is there noise in the hydraulic cylinder of the excavator lift arm?
There is no noise of a normal cylinder, check whether the throttle is ringing, or the mechanical part connected with it is ringing, and the mechanical part can be greased. If it can't be ruled out, disconnect the cylinder from the mechanical part and act alone to see what the situation is.