This article mainly introduces:

Australia hydraulic cylinder,push plate cylinder manufacturer,push plate cylinder

(Australia push plate cylinder,produced by Hengyu Hydraulic Cylinder Factory）

push plate cylinder are widely used in Australia，because of no need for deceleration device，long service life，smooth movement.So our company has designed push plate cylinder for customers from Australia.

Introduction to push plate cylinder:

When the push plate cylinder is installed, the piston and the push plate cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the push plate cylinder head boss is easy to cause scars when it hits the inner surface of the push plate cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized push plate cylinders, only careful and careful operation can be avoided.

The definition of the minimum starting pressure of the push plate cylinder refers to the minimum working pressure of the push plate cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the push plate cylinder parts and the size of the sealing friction.

The push plate cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating motion (or swinging motion). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the push plate cylinder is proportional to the effective area of the piston and the pressure difference between the two sides; The push plate cylinder is basically composed of push plate cylinder and push plate cylinder head, piston and piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential.

If it is found that the push plate cylinder lubrication is poor or the push plate cylinder bore processing is abnormal, it is necessary to feedback the situation to the manufacturer, because the piston and the push plate cylinder, the guide rail and the piston rod have relative movement, if the lubrication is poor or the push plate cylinder bore is abnormal, it will aggravate the wear and reduce the straightness of the push plate cylinder center line. In this way, when the piston works in the push plate cylinder, the friction resistance will be large and small, resulting in slip or crawling. The solution is to repair and grind the push plate cylinder first, and then prepare the piston according to the matching requirements, repair and grind the piston rod, and configure the guide sleeve.

Answers to some questions about push plate cylinder:

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.

What is the difference between hydraulic piston cylinder and plunger cylinder?
The force surface of the piston cylinder is a rod cavity and a rodless cavity, and the force surface of the plunger cylinder is the plunger, the spring return single-acting piston cylinder can also rely on the external force of the spring to achieve return, the double-acting piston cylinder can produce tension, and the plunger cylinder only produces thrust without tension.