This article mainly introduces:

Libya hydraulic cylinder,pushing cylinder manufacturer,pushing cylinder

(Libya pushing cylinder,produced by Hengyu Hydraulic Cylinder Factory）

pushing cylinder are widely used in Libya，because of long service life，smooth movement，high work efficiency.So our company has designed pushing cylinder for customers from Libya.

Introduction to pushing cylinder:

pushing cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the pushing cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the pushing cylinder. c. The pushing cylinder seal is extruded, if the O-ring is obviously extruded at the pushing cylinder seal, replace the pushing cylinder seal.

The pushing cylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

The repair method of pushing cylinder wear: 1. Metal repair material is applied to the scratched surface; The first layer should be thin, uniform and fully covered with the scratched surface to ensure the best adhesion between the material and the metal surface, and then apply the material to the entire repair site and press repeatedly to ensure that the material is filled and reaches the required thickness, so that it is slightly higher than the surface of the guide rail; 2, the material at 24℃ to fully achieve the performance of 24 hours, in order to save time, can be through the tungsten halogen lamp to increase the temperature, the temperature rises 11℃, the curing time will be reduced by half, the best curing temperature 70℃; 3. After the material is cured, use a fine grinding stone or a scraper to repair and smooth the material higher than the surface of the guide rail, and the construction is completed.

When the pushing cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the pushing cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

Answers to some questions about pushing cylinder:

What is the thin cylinder used for?
The principle is no different from ordinary cylinders, that is, the installation space is small, the formation is small, and it is suitable for some special occasions. For example, the space is compact and the place of small travel is used.

What is the function of the Reza mounted master cylinder?
The role of the Resa-mounted master cylinder is to pump the concrete from the hopper to the delivery pipe and to provide sufficient concrete outlet pressure so that the concrete can reach the specified location.