This article mainly introduces:

Kenya hydraulic cylinder,sanitation truck hydraulic cylinder manufacturer,sanitation truck hydraulic cylinder

(Kenya sanitation truck hydraulic cylinder,produced by Hengyu Group）

sanitation truck hydraulic cylinder are widely used in Kenya，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed sanitation truck hydraulic cylinder for customers from Kenya.

Introduction to sanitation truck hydraulic cylinder:

sanitation truck hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. sanitation truck hydraulic cylinder selection specifications are too small. Leakage in sanitation truck hydraulic cylinder or associated hydraulic system element.

The commonly used buffer structure of the sanitation truck hydraulic cylinder is composed of a piston boss and a sanitation truck hydraulic cylinder head groove. When the piston moves close to the sanitation truck hydraulic cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The material, shape and compression of the sanitation truck hydraulic cylinder seal have a great impact on the service life and work efficiency of the sanitation truck hydraulic cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

The difference between the plunger sanitation truck hydraulic cylinder and the piston sanitation truck hydraulic cylinder is that the piston in the sanitation truck hydraulic cylinder is replaced by a shaft plunger, which is used in hydraulic transmission requiring a long mechanical stroke, and can only input pressure oil from one direction, pressurize in a single direction, and form a thrust to push the plunger to move. The return trip of the plunger depends on the plunger itself to fall, and some rely on the spring to push back to the original position. Usually used plunger type sanitation truck hydraulic cylinder, its inner hole does not need mechanical finishing, as long as the plunger round grinding can be assembled.

Answers to some questions about sanitation truck hydraulic cylinder:

Is there a way to make the cylinder stop pushing when it hits something hard during the process of pushing?
The simplest solution is to press the stop switch, this switch has a mechanical type, touch the object on the action or send a stop signal, through the operation of the motor control cylinder; There is also an induction switch, that is, when the hydraulic cylinder expands to the range of the induction switch can sense the signal, it sends a signal to let the motor act, resulting in the corresponding action of the cylinder.

How to calculate cylinder pressure?
Hydraulic pressure area of cylinder × hydraulic pressure = output force of cylinder 200mm=20cm 100mm=10cm 15Mpa=150Kg/cm2 Cylinder thrust: 3.14×10×10 area ×150 pressure =47100Kg=47.1t cylinder pulling force: 3.14×(10×10-5×5) Area ×150 pressure =35325Kg=35.325t The above calculation did not consider the resistance of oil return, because you did not provide oil return pressure. But the impact should be small.