This article mainly introduces:

Poland hydraulic cylinder,rack cylinder manufacturer,rack cylinder

(Poland rack cylinder,produced by Hengyu Group）

rack cylinder are widely used in Poland，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed rack cylinder for customers from Poland.

Introduction to rack cylinder:

The "O" ring can be used as an auxiliary seal inside the rack cylinder, and the elastic force of the "O" ring makes the sealing slip ring close to the sealing surface, generating sealing pressure to achieve sealing. When the internal hydraulic pressure increases, the "O" ring will further deform and squeeze the slip ring, thereby increasing the sealing pressure and improving the sealing performance. The structure has the characteristics of low friction coefficient, good wear resistance, automatic compensation for wear and absorption of hard particles in the rack cylinder, and can be completely sealed.

The daily inspection of the rack cylinder includes: checking the connection of the rack cylinder and the pipe joint for leaks. Check the rack cylinder rod for leaks. Check the rack cylinder connection for leaks. When the rack cylinder moves, the work is normal and smooth. Whether the rack cylinder has internal leakage.

When the long-stroke rack cylinder rotates horizontally, the piston rod bends due to its own weight, causing the guide sleeve and piston to produce biased load, resulting in rack cylinder head seal damage, oil leakage, and piston sleep in the rack cylinder. The following measures can be taken: increase the piston plan to adjust the piston outer circle and process it into a convex drum, so that the piston can self-position, improve the force situation, and reduce and avoid pulling the rack cylinder; The piston and the piston rod are connected with a spherical joint.

rack cylinder piston sealing is best to use Yx ring, polyurethane and polytetrafluoroethylene sealing material combination, can significantly improve the sealing performance: (I), reduce friction resistance, no crawling phenomenon; (ii) Have good dynamic and static sealing, wear resistance, long service life; (iii) The installation groove is simple, and the disassembly is simple.

Answers to some questions about rack cylinder:

What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.

How to deal with oil cylinder leakage?
The causes of oil leakage and treatment methods are as follows: (1) The spool is stuck or the valve hole is blocked. When the spool of the flow valve or direction valve is stuck or the valve hole is blocked, the hydraulic cylinder is prone to misoperation or operation failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check valve body for wear. (2) The piston rod and cylinder are stuck or the hydraulic cylinder is blocked. At this time, no matter how to operate, the hydraulic cylinder does not move or moves very little. At this time, it should be checked whether the piston and piston rod seal is too tight, whether it enters the dirt and colloid precipitate: whether the shaft line of the piston rod and the cylinder is in alignment, and whether the wearing parts and seals are invalid.