This article mainly introduces:

Ireland hydraulic cylinder,100 ton hydraulic cylinder manufacturer,100 ton hydraulic cylinder

(Ireland 100 ton hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

100 ton hydraulic cylinder are widely used in Ireland，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed 100 ton hydraulic cylinder for customers from Ireland.

Introduction to 100 ton hydraulic cylinder:

There are some honeycomb holes in the inner wall of the 100 ton hydraulic cylinder, piston or piston rod surface. How is this formed? When we repair the 100 ton hydraulic cylinder, we can see that there are some honeycomb holes on the inner wall of the 100 ton hydraulic cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the 100 ton hydraulic cylinder is targeted to prevent. Is very necessary.

100 ton hydraulic cylinder head explanation: low pressure castings, medium and low pressure with HT300 gray iron, medium and high pressure with 35, 45 steel. When the 100 ton hydraulic cylinder head itself is the guide sleeve of the piston rod, the 100 ton hydraulic cylinder head is best cast iron. At the same time, brass, bronze or other wear-resistant materials should be fused on the guide surface. If the guide sleeve is pressed into the 100 ton hydraulic cylinder head, the guide sleeve shall be wear-resistant cast iron, bronze or brass.

The pressure of the sliding surface of the 100 ton hydraulic cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the 100 ton hydraulic cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

The 100 ton hydraulic cylinder is not the same as the 100 ton hydraulic cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the 100 ton hydraulic cylinder can not be used as a high-power power component, but the 100 ton hydraulic cylinder can be used as a relatively large power component, or the 100 ton hydraulic cylinder system can be used.

Answers to some questions about 100 ton hydraulic cylinder:

When the hydraulic cylinder changes from fast to slow, how can the slow speed become more even and the speed can be adjusted?
Reversing valve set 2 reversing valves. The back of one valve goes directly to the cylinder, running at full speed for fast action. Add a speed control valve behind the other valve, and then connect to the cylinder to achieve slow action, you can adjust the opening of the speed control valve, to achieve the speed of the cylinder can be adjusted. An import speed control valve to more than 1,000 yuan, if you think it is too expensive, you can also use the throttle valve instead. However, the throttle valve is greatly affected by the load change.

Why does the hydraulic cylinder rebound after the rod cavity is extended into place?
The reason is that after the rod cavity is extended into place, the rod cavity and the rodless cavity are connected, so that the cylinder moves towards the rod cavity. After connecting, it is equivalent to the hydraulic oil directly driving the cylinder with an area equal to the piston rod. After the end of this problem, it is estimated that the seal is not very good, and the two cavities are connected after the pressure is increased to a certain extent; Or there is a problem in the valve, so that the two chambers are connected after reaching a certain pressure. Other phenomena: If the load is increased to a certain extent, no matter which side of the solenoid valve is energized, the cylinder will move to the rod cavity.