This article mainly introduces:

The Philippines hydraulic cylinder,hydraulic engineering cylinder manufacturer,hydraulic engineering cylinder

(The Philippines hydraulic engineering cylinder,produced by Hebei Hengyu company）

hydraulic engineering cylinder are widely used in The Philippines，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed hydraulic engineering cylinder for customers from The Philippines.

Introduction to hydraulic engineering cylinder:

hydraulic engineering cylinder body inspection: The inner surface of the hydraulic engineering cylinder and the piston seal are the main factors causing the leakage in the hydraulic engineering cylinder, if the hydraulic engineering cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the hydraulic engineering cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

The hydraulic engineering cylinder requires that the filtration accuracy of the system is not less than the 80um, and the oil pollution should be strictly controlled, the oil should be kept clean, the performance of the oil should be checked regularly, and the necessary fine filtration and replacement of new working oil should be carried out.

At the rated pressure, the thrust of the hydraulic engineering cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the hydraulic engineering cylinder is related to the diameter of the hydraulic engineering cylinder, but not to the stroke of the hydraulic engineering cylinder. Moreover, the larger the hydraulic engineering cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the hydraulic engineering cylinder.

hydraulic engineering cylinder spool stuck or valve hole blocked How to solve: When the flow valve or direction valve spool stuck or valve hole blocked, the hydraulic engineering cylinder prone to misoperation or action failure. At this time, the contamination of the oil should be checked; Check whether dirt or colloidal deposits are stuck in the spool or blocking the valve hole; Check the wear of the valve body, clean and replace the system filter, clean the fuel tank, and replace the hydraulic medium.

Answers to some questions about hydraulic engineering cylinder:

How to repair if hydraulic shears cylinder oil leakage?
The hydraulic cylinder is generally disassembled and the sealing ring is replaced. There are generally two ways to install the ends of the hydraulic cylinder. The larger hydraulic cylinder is mostly flanged disc type, which is screwed to the middle cylinder block by several bolts, the bolts are removed, and the cylinder head is slowly pulled out. The smaller hydraulic cylinder, the cylinder block and the head itself are threaded, and the rotating end cap can be removed from the cylinder block. If you do not understand the hydraulic cylinder, it is best to ask someone to deal with it. It is easy to damage the sealing ring and internal surface during disassembly.

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).