This article mainly introduces:

Guatemala hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Guatemala stacker cylinder,produced by Hebei Hengyu company）

stacker cylinder are widely used in Guatemala，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed stacker cylinder for customers from Guatemala.

Introduction to stacker cylinder:

Most of the failure of the stacker cylinder is because there is a foreign body in the stacker cylinder into the failure of the stacker cylinder, the most problematic is that it is difficult to determine when the foreign body is into the stacker cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

The commonly used buffer structure of the stacker cylinder is composed of a piston boss and a stacker cylinder head groove. When the piston moves close to the stacker cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

The internal leakage of the stacker cylinder is an important indicator to measure the quality of the stacker cylinder: the internal leakage of the stacker cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the stacker cylinder, so that the stacker cylinder can not accurately and stably stop in a certain position of the stacker cylinder, so it is one of the main indicators of the stacker cylinder.

If the stacker cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

Answers to some questions about stacker cylinder:

Two cylinders in parallel, how to solve the synchronization problem?
The following methods can be used to achieve parallel cylinder synchronization: 1, rigid mechanical synchronization. 2. The throttle valve or speed regulating valve is used in the circuit to adjust the synchronization. 3, the two cylinders use independent quantitative pump oil supply to achieve synchronization. 4. Synchronous motor is used in the loop to realize cylinder synchronization. 5, using the position sensor to measure the stroke position and control the cylinder synchronization through the electrical system.

How to repair the bent oil cylinder correctly?
If the bending oil cylinder leaks, the most direct way is to replace the seal ring. Most of the sealing rings used by domestic bending machines are made in Taiwan and Japan, so the service life of the sealing ring is still relatively long. If the bending oil cylinder used by the customer leaks oil, then when replacing the seal ring, be sure to choose a high-quality and durable seal ring. In this way, the replaced cylinder will not leak oil for a long time.