This article mainly introduces:

Cameroon hydraulic cylinder,press hydraulic cylinder manufacturer,press hydraulic cylinder

(Cameroon press hydraulic cylinder,produced by Hebei Hengyu company）

press hydraulic cylinder are widely used in Cameroon，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed press hydraulic cylinder for customers from Cameroon.

Introduction to press hydraulic cylinder:

In the process of using the press hydraulic cylinder, sometimes such a problem will occur, the press hydraulic cylinder can not act immediately after the instruction of the press hydraulic cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil press hydraulic cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

press hydraulic cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the press hydraulic cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the press hydraulic cylinder. c. The press hydraulic cylinder seal is extruded, if the O-ring is obviously extruded at the press hydraulic cylinder seal, replace the press hydraulic cylinder seal.

The pressure of the sliding surface of the press hydraulic cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the press hydraulic cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

The press hydraulic cylinder should be used correctly and maintained regularly. The press hydraulic cylinder should be deflated before use, the buffer regulating valve should be adjusted to a reasonable position, the cleanliness of the oil should be checked regularly, the dust on the press hydraulic cylinder should be cleaned regularly, and attention should be paid to waterproof and fireproof.

Answers to some questions about press hydraulic cylinder:

In a hydraulic system, a hydraulic pump has many hydraulic cylinders and hydraulic motors, and these executive components do not coordinate their actions with each other.
A load-sensitive variable pump can be used if these components sometimes need to work simultaneously and the power required is large. The required flow is distributed by the multi-way reversing valve, and the required flow and pressure changes are automatically adjusted by the hydraulic pump. Pressure reducing valves can be used for particularly low pressure circuits. Because you execute more components, the use of quantitative pump will cause a waste of energy, the system heat is large, not suitable.

What is the valve on the hydraulic cylinder?
Oil valve, relief valve, overload valve, explosion-proof valve, etc., these are very convenient to insert! The oil valve, the overload valve and the blasting valve are very important for larger cylinders. Manufacturers will not offer you the selection. You need to choose the values by yourself according to your system, pump, cylinder, environment, working conditions and other comprehensive consideration!