This article mainly introduces:

Oman hydraulic cylinder,unidirectional cylinder manufacturer,unidirectional cylinder

(Oman unidirectional cylinder,produced by Hengyu Group）

unidirectional cylinder are widely used in Oman，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed unidirectional cylinder for customers from Oman.

Introduction to unidirectional cylinder:

When the unidirectional cylinder is in use, ensure that the unidirectional cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

Factors that should be considered when selecting the oil seal in the unidirectional cylinder: some specific factors should be taken into account when selecting the oil seal in the unidirectional cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: unidirectional cylinder diameter, piston rod diameter, piston rod and piston groove size, unidirectional cylinder working pressure, unidirectional cylinder movement speed, hydraulic system oil temperature and unidirectional cylinder working environment.

When the control pressure of the hydraulic system is too low, the unidirectional cylinder will appear wrong or no action, because the throttle resistance in the control pipeline may be too large, the flow valve is improperly adjusted, the control pressure is inappropriate, and the pressure source is interfered with. At this time, check the control pressure source to ensure that the pressure is adjusted to the specified value of the system.

The unidirectional cylinder should be vented: when the unidirectional cylinder is installed or parked for a long time to work again, the air will penetrate into the unidirectional cylinder and the pipeline system. In order to prevent the abnormal phenomenon of crawling, noise and heating of the actuator, the air in the unidirectional cylinder and the system should be discharged. In order to facilitate the removal of air deposited in the unidirectional cylinder, the oil is best entered and discharged from the highest point of the unidirectional cylinder. unidirectional cylinders that require higher motion stability are often equipped with exhaust plugs at both ends. Before working, unscrew the exhaust plug to make the piston go back and forth several times without load in the whole stroke, and the air can be discharged through the exhaust plug. After the air is drained, tighten the exhaust plug before working.

Answers to some questions about unidirectional cylinder:

How does the cylinder of the shearing machine work?
Plate shear is a machine that cuts a sheet with a reciprocating straight motion from one blade to another. Through the moving upper blade and the fixed lower blade, the shear force is applied to the metal sheet of various thicknesses with a reasonable blade gap, so that the sheet is broken and separated according to the required size. Shearing machine belongs to one of the forging machinery, the main role is the metal processing industry. Products are widely used in aviation, light industry, metallurgy, chemical industry, construction, shipbuilding, automobile, electric power, electrical appliances, decoration and other industries to provide the required special machinery and complete sets of equipment. Working principle: The hydraulic system is used to drive the hydraulic cylinder to output a strong shear force to complete the shearing work.

What is a hydraulic cylinder assembly?
Assembly, which means aggregate. A series of parts or products, formed to achieve a specific function of the whole, the general term for this system is assembly. The hydraulic cylinder assembly is not a single hydraulic cylinder part, which can be used by connecting the hydraulic hose.