This article mainly introduces:

Australia hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Australia steel mill cylinder,produced by Hengyu Hydraulic Co., Ltd）

steel mill cylinder are widely used in Australia，because of no need for deceleration device，long service life，smooth movement.So our company has designed steel mill cylinder for customers from Australia.

Introduction to steel mill cylinder:

The main role of the steel mill cylinder: the steel mill cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the steel mill cylinder realizes reciprocating motion. The structure of the steel mill cylinder has three categories: piston steel mill cylinder, plunger steel mill cylinder, swing steel mill cylinder, piston steel mill cylinder and plunger steel mill cylinder to achieve reciprocating linear motion, output speed and thrust, swing steel mill cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the steel mill cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The steel mill cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

Regular maintenance of the steel mill cylinder includes: regular tightening, steel mill cylinder fastening screws and gland screws, steel mill cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the steel mill cylinder once a year. Clean regularly, the steel mill cylinder is cleaned every other year, and the seals are replaced while cleaning.

The pressure of the sliding surface of the steel mill cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the steel mill cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

The definition of the minimum starting pressure of the steel mill cylinder refers to the minimum working pressure of the steel mill cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the steel mill cylinder parts and the size of the sealing friction.

Answers to some questions about steel mill cylinder:

What are the reasons why the hydraulic cylinder action is slower than normal?
There are many factors that cause this problem. First, measure the pressure of the main system to see whether the pressure of the main system under the pressure state is consistent with the initial setting. Before measuring the pressure, it is best to check the hydraulic oil and suction oil filter and replace or clean it. Second, check the main relief valve of the reversing control multiway valve to see if there is damage or foreign matter blocking, and clean it. If your pump is a gear pump, the problem should generally be small. Second, look at traffic. There is no leakage in the cylinder, leakage in the reversing valve spool and so on.

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).