This article mainly introduces:

Britain hydraulic cylinder,magnetic ring induction cylinder manufacturer,magnetic ring induction cylinder

(Britain magnetic ring induction cylinder,produced by Hengyu Hydraulic Co., Ltd）

magnetic ring induction cylinder are widely used in Britain，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed magnetic ring induction cylinder for customers from Britain.

Introduction to magnetic ring induction cylinder:

When the oil pressure of the magnetic ring induction cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

Do not regularly check the damage of the chrome layer of the magnetic ring induction cylinder: completely extend the magnetic ring induction cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the magnetic ring induction cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the magnetic ring induction cylinder seal. Welding slag is strictly prohibited on the surface of the magnetic ring induction cylinder.

magnetic ring induction cylinder daily maintenance, should focus on checking whether the piston rod surface roughness and shape and position tolerance meet the technical requirements, if the piston rod bending should be calibrated to meet the requirements or according to the physical mapping, manufactured by a professional manufacturer. If the piston rod surface coating wear, slip damage, local spalling can be adopted to remove the coating, re-chrome surface processing process.

The viscosity of the working oil used in the magnetic ring induction cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

Answers to some questions about magnetic ring induction cylinder:

How big is the motor and oil pump for the 80 cylinder?
Pump motor selection is not only related to cylinder diameter but also speed system, it is recommended to provide system diagram and speed requirements, generally speaking, most of the 80 cylinder on the market is equipped with 3-4KW motor, 10-20 oil pump.

How do hydraulic equipment and hydraulic cylinders maintain a certain pressure after pressing to a certain position?
There are several methods. 1. You can use a constant pressure variable pump to adjust the control pressure of the pump to the pressure required by the cylinder, so that when the cylinder is in place, the pump uses the minimum flow rate to maintain the pressure, and the system is more energy saving. 2. If the pressure is maintained for a short time, a hydraulic control check valve can be added to the oil inlet end of the cylinder to close the cylinder and maintain the pressure. If the volume of the cylinder is large, an accumulator can be added between the valve and the cylinder to maintain pressure for 10-30 minutes. 3. You can add a small flow pump, the large pump after unloading, the small pump has been running, specifically for maintaining pressure.