This article mainly introduces:

Singapore hydraulic cylinder,land leveller hydraulic cylinder manufacturer,land leveller hydraulic cylinder

(Singapore land leveller hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

land leveller hydraulic cylinder are widely used in Singapore，because of no need for deceleration device，long service life，smooth movement.So our company has designed land leveller hydraulic cylinder for customers from Singapore.

Introduction to land leveller hydraulic cylinder:

Before purchasing the land leveller hydraulic cylinder, it is necessary to master the original information and design basis, mainly including: the use and working conditions of the machine; The structural characteristics, load conditions, stroke size and operation requirements of the working mechanism; The selected working pressure and flow of the hydraulic system; The reality of materials, fittings and processes; Relevant national standards and technical specifications, etc.

Because of the slightly complex structure of the buffer land leveller hydraulic cylinder, sometimes there will be problems, such as when the land leveller hydraulic cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

Before the land leveller hydraulic cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

There are some honeycomb holes in the inner wall of the land leveller hydraulic cylinder, piston or piston rod surface. How is this formed? When we repair the land leveller hydraulic cylinder, we can see that there are some honeycomb holes on the inner wall of the land leveller hydraulic cylinder, the piston or the piston rod surface, which are caused by cavitation. Therefore, the cavitation of the land leveller hydraulic cylinder is targeted to prevent. Is very necessary.

Answers to some questions about land leveller hydraulic cylinder:

How many tons can a 10mpa cylinder with a diameter of 100 hold up?
About 8 tons. Algorithm: Cylinder cross-sectional area = π* (100/2) ^2=3.14*2500=7850 square mm = 0.00785 square meters pressure = pressure * Cross-sectional area = 10000000Pa*0.00785 square meters = 78500 n mass = pressure /g = 78500 N ÷9.8 n/kg = 8010 kg = 8.01 Tons.

What is st represented in the cylinder formula?
St is the original unit of kinematic viscosity, the abbreviation of Stokes, that is, Stokes, short for S. cm2/s has now been used. 1 s (St) = 10^-4m2/s.