This article mainly introduces:

Sudan hydraulic cylinder,series synchronous cylinder manufacturer,series synchronous cylinder

(Sudan series synchronous cylinder,produced by Hengyu Group）

series synchronous cylinder are widely used in Sudan，because of no transmission clearance，clever hydraulic energy conversion，powerful torque.So our company has designed series synchronous cylinder for customers from Sudan.

Introduction to series synchronous cylinder:

In order to ensure the service life of the series synchronous cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the series synchronous cylinder, causing damage to the seal and causing leakage in the series synchronous cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

series synchronous cylinder body inspection: The inner surface of the series synchronous cylinder and the piston seal are the main factors causing the leakage in the series synchronous cylinder, if the series synchronous cylinder has a longitudinal tensile mark, even if the new piston seal is replaced, it can not effectively eliminate the fault, the inner surface of the series synchronous cylinder mainly checks whether the dimensional tolerance and shape and position tolerance meet the technical requirements, there is no longitudinal tensile mark, and measures the depth of the longitudinal tensile mark, in order to take the corresponding solution.

When installing the piston rod, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the series synchronous cylinder head adn the earring (or the middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent the phenomenon of rigid interference and causing unnecessary damage.

Do not regularly check the damage of the chrome layer of the series synchronous cylinder: completely extend the series synchronous cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the series synchronous cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the series synchronous cylinder seal. Welding slag is strictly prohibited on the surface of the series synchronous cylinder.

Answers to some questions about series synchronous cylinder:

Does the sealing string of the upper and lower chamber of the hydraulic cylinder fall by itself?
It is possible, the probability accounts for 85% (depending on the weight), the weight is less than the system resistance, may not fall, the weight is greater than the system resistance, will not necessarily fall, so often check the equipment, safety first, find the problem in time to solve, the cylinder is not very expensive parts, maintenance does not cost much money, However, accidents caused by cylinder failure will lose several times the cost.

Hydraulic cylinder load algorithm?
If it is thrust, load = working pressure x piston area. If it is pulling force, load = working pressure x(piston area - piston rod area).