reset cylinder(reset cylinder,produced by Hebei Hengyu company）reset cylinder are widely used ，because of no transmission clearance，powerful torque，clever hydraulic
(reset cylinder,produced by Hebei Hengyu company）
reset cylinder are widely used ，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed reset cylinder for our customers.
The commonly used buffer structure of the reset cylinder is composed of a piston boss and a reset cylinder head groove. When the piston moves close to the reset cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.
reset cylinder installation precautions: Before installing the reset cylinder into the system, the parameters on the reset cylinder label should be compared with the parameters when ordering. The base of the reset cylinder must have sufficient stiffness, otherwise the reset cylinder will bend upward into a bow when pressurized, so that the piston rod will bend.
reset cylinder piston sealing is best to use Yx ring, polyurethane and polytetrafluoroethylene sealing material combination, can significantly improve the sealing performance: (I), reduce friction resistance, no crawling phenomenon; (ii) Have good dynamic and static sealing, wear resistance, long service life; (iii) The installation groove is simple, and the disassembly is simple.
If the piston rod and reset cylinder are stuck or the reset cylinder is blocked, at this time, no matter how to operate, the reset cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the reset cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.
Can one hydraulic pump with two cylinders work?
A hydraulic pump with two cylinders will work. Commonly used hydraulic pump types: 1, according to whether the flow can be adjusted can be divided into: variable pump and quantitative pump. The output flow can be adjusted according to the needs of the variable pump, the flow can not be adjusted called quantitative pump. 2, according to the pump structure commonly used in the hydraulic system is divided into: gear pump, vane pump and plunger pump 3 kinds. Gear pump: small volume, simple structure, the cleanliness of the oil requirements are not strict, the price is cheaper; However, the pump shaft is subjected to unbalanced force, serious wear and leakage. Vane pump: divided into double acting vane pump and single acting vane pump. The pump has uniform flow, smooth operation, low noise, higher pressure and volumetric efficiency than gear pump, and more complex structure than gear pump.
How to judge the leakage in the cylinder?
Common judgment method: In the production site, people make full use of watching, listening, smelling, touching and other sensory ways, by observing that the cylinder can not move or delay the action or feel the oil temperature change, vibration and noise, etc., and then judge whether the cylinder has internal leakage according to experience. Another method commonly used in the field is to extend the cylinder in place to ensure that the cylinder does not have any load and will not retract (to prevent the cylinder from internal leakage accidents), turn off the machine, and then remove the tubing with the rod cavity, and then press the switch that pulls out the cylinder (do not press the wrong switch). If the oil nozzle with the rod cavity drains the cylinder internally, If there's no oil coming out, you have to think about something else going wrong.
Add Wechat